|
| |
| Handle: |
souNdguy |
|
| Project Name: |
740 |
|
| Tractor: |
740 |
|
| Started: |
07:03 01/14/10 |
|
| Updated: |
04:32 03/26/11 |
|
|
| Expand/Contract all Journal Entries Show newest journal entry on top |
07:08 01/14/10
07:08 01/14/10
|  07:08 01/14/10 My new 740Found this baby in north east georgia.. took over a year and a half of dickering with the owner to get him to let it go.
finally got a break in work and drove up with a buddy and picked her up.. was about a 16hr round trip. Just got her home, she's still on the trailer. Right off the bat I know I will need to rebuild the hyds and steering system. I don't think she charges ( alternator conversion in place.. but ratty looking ). Does seem to hold good oil pressure, and no water in the crankcase oil. took a bit of coaxing and a hot battery to get her to start inthe 20' weaker.. but she fired up after some choking and cranking over and crawled up on the trailer under her own power. I've enclosed pic of her followign me hom on 285 in ga, plus one where we pulled over at a BBQ place to eat.
soundguy | | |
|
|  | 16:44 01/14/10 first dayhad some time after the daily chores to play..er work on the 740.
got the 3pt hitch working.. though needs a oil change and sump cleaning..
de-haired some of the wireing and got her to charge..
got the lamps working
solenoid is a little dodgey.. will replace it.. and think that is the bulk of the cranking problems.. not the starter itself.. though I won't be able to verify that for sure until I replace the old buzzy solenoid. I got a spare old but working starter on the shelf if I need a swap.
got the steering adjusted.. might not rebuild it at this time.. it actually adjusted out pretty good..
I think this weekend I will get all her vital fluids changed and flushed and give her a test ride around the pasture.. the shifter ont he tranny is a lil stiff.. but I think will free up with use.. according to the prev owner.. she has been parked for the better part of last year in a shed, and the year before that wasn't used very much either. | | |
|
| | 12:30 01/16/10 1-16-10finished flushing the steering pedistal, and refilled with oil.
drained and flushed the hydro sump// had lotsa water init, so flushed with a quart of atf and a gallon of diesel, let circulate, then drained.. did it again.. came out clean.. then refilled with oil.
drained the gear reduction boxes, flushed with kerosene, and the diffy as well, then refilled with oil.
still need to work on the tranny and drain / flush and pull top to replace start switch.
have rigged the alt to work, but it still needs more work.
need to replace the solenoid before I can correctly evaluate the starter.
have ordered a oem choke knob. | | |
|
| 
17:54 01/18/10
| 17:54 01/18/10 1-18-10put on a new thumb start switch and start solenoid. got the charge circuit working a lil more 'automagical' with the addition of a diode and resistor.
got the trans oil drained, flushed, and changed.
have the air cleaner off in order to do the solenoid and left it off as I will be pulling the tin to rebuild the steering box perhaps as early as this weekend.
cnh had a trans cover gasket.. and tsc had the switch.
soundguy | | |
|
| | 18:50 01/20/10 1-20-10Had to cut the steering wheel off by splitting the hub so i could finsh working on the steering box.. got it adjusted and lubed. Boy.. those rowcrop steering boxes sure are a bit different than the regular ford boxes...
installed a dash lamp and got the sheet metal buttoned back up and installe dthe air cleaner and battery.
I have a couple more little things to do, then she will be ready for some test driving around the pasture to see how she does.
soundguy | | |
|
| | 09:50 01/22/10 1-22-10| got some touch up painting done today.. still need to work on 1 rim, but ran out of time | | |
|
| 
13:08 01/23/10
13:08 01/23/10
13:08 01/23/10
13:08 01/23/10
| 13:08 01/23/10 1-23-10| Did a minor repair on 1 rear rim, may consider replacing that rim when i put new tires on her, but for now it will run. Cleaned the fuel system and put in some fresh gas, and then took a couple joy rides around the pasture and adjusted the carb. | | |
|
| | 09:08 02/03/10 tiresgot one tire on friday jan 29th.. spent that morning putting it on... got the 6 rim bolt sout with the usualy issues.. pipe, breaker bar, air gun.. etc.
got my other tire today, feb 3.. pulled the bolts on it on monday the 1st.. 2 came out like the other 6, one wrung the nut off, and the other 3 I had to cut them out :( | | |
|
| | 15:27 02/05/10 2-5-10got the other tire on wed with the help of a buddy, after work.
touched up the rims and centers to get rid of the spoon marks.
fixed an exhaust leak and improvised a lower foot step under the running board.. still waiting for pto partd.
soundguy | | |
|
| 
19:38 02/10/10
| 19:38 02/10/10 2-10-10| got some busy work done... tires were put on last week.. getting ready to snatch pto shaft out.. repalced check chains, got some decals on. | | |
|
| | | |
|
| | Return to Journal list |
|
What are Project Journals?
Project Journals are a place where YT Community members can document their tractor and farm projects. Each journal created, can have many photos and accompanying text entries. You can also enable comments to allow other members of the YT Community to comment on your journal. If you do enable comments, it is up to you to moderate what people enter in your journal according to the site policy of Yesterdays Tractors. Journals may also be used as photo posting area, to post your photos of your farm, tractors and related photo topics. If you would like to create a journal, just be sure you are logged in to the Classic View of the forums, and a link will appear to do so when you next come to this page.
. |
Home
| Forums
Today's Featured Article -
Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
