|
Tune-Up Specifications - B.F. Avery |
This data has been gathered from old out-of-print material. While
we make every effort to be accurate, the information shown is to
be used for general reference only. It is always best to have
the original service or operator's manual for your tractor before
attempting any tuneup.
There is a legend at the bottom of the page describing some of the terms used here.
|
Model
|
Point Gap
|
Spark Plug Gap
|
Timing Mark On
|
Spark Occurs
|
Firing Order
|
Int. Valve Clearance
|
Exh. Valve Clearance
|
Comments
|
|
V |
.020 |
.028 |
FLY |
TDC |
1-2-4-3 |
.006H |
.006H |
|
|
A & R |
.020 |
.025 |
FLY |
TDC |
1-2-4-3 |
.008C |
.010C |
Point gap for Magneto set to .015 |
| Legend |
|---|
- TDC - Top Dead Center
- FP - Crankshaft Fan Drive Pulley
- Exh - Exhaust
- Int - Intake
- ATDC - After Top Dead Center
- BTDC - Before Top Dead Center
|
|
Data collected from an old Niehoff tune-up chart.
|
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
Massey Ferguson i65 Tractor for sale
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
